This is a 2003, 2 spindle glass edger. The original steel work including frame, wheel compartment, front and rear conveyors, in-feed and out-feed conveyors, vertical supports and covers are the original OEM which was sandblasted to the bare metal and powder painted. Powder paint is a much stronger harder paint application than the original paint, and will last longer. The control panel was also fully upgraded with a new grinding wheel switch, new polish wheel switch, new pump switch, new DC controller, new forward and reverse rocker switch and a new variable speed potentiometer and updated door and face plate. Plumbing was also upgraded with a new pump and recirculating coolant tank. New spindle and bearings were installed for the diamond wheel motor. Diamond and polish wheel motor’s were disassembled and had new bearings installed. This edger also got a new drive chains, new front and rear pads along with new in-feed and out-feed conveyor belts. All of the brushes have been replaced along with new rubber wipers and rubber curtain.